DITHEN=DISABLED, LCKIEN=DISABLED, HLMTF=NOT_SET, LLMTF=NOT_SET, EDGSEL=FALLING_EDGE, LMTIEN=DISABLED, OUTMD=OFF, LCKI=NOT_SET, LCKPOL=ACTIVE_LOW, STALL=DISABLED, REFSEL=RTC0TCLK
Module Control
| LLMTF | CAL Saturation (Low) Flag. 0 (NOT_SET): DCO period is not saturated low. 1 (SET): DCO period is saturated low. |
| HLMTF | CAL Saturation (High) Flag. 0 (NOT_SET): DCO period is not saturated high. 1 (SET): DCO period is saturated high. |
| LCKI | Phase-Lock and Frequency-Lock Locked Interrupt Flag. 0 (NOT_SET): DCO is disabled or not locked. 1 (SET): DCO is enabled and locked. |
| LMTIEN | Limit Interrupt Enable. 0 (DISABLED): Saturation (high and low) interrupt disabled. 1 (ENABLED): Saturation (high and low) interrupt enabled. |
| LCKIEN | Locked Interrupt Enable. 0 (DISABLED): The PLL locking does not cause an interrupt 1 (ENABLED): An interrupt is generated if LCKI matches the state selected by LCKPOL. |
| LCKPOL | Lock Interrupt Polarity. 0 (ACTIVE_LOW): The lock state PLL interrupt will occur when LCKI is 0. 1 (ACTIVE_HIGH): The lock state PLL interrupt will occur when LCKI is 1. |
| REFSEL | Reference Clock Selection Control. 0 (RTC0TCLK): PLL reference clock (FREF) is the RTC0 oscillator (RTC0TCLK). 1 (LPOSC0DIV): PLL reference clock (FREF) is the divided Low Power Oscillator (LPOSC0). 2 (EXTOSC0): PLL reference clock (FREF) is the external oscillator output (EXTOSC0). |
| LOCKTH | Lock Threshold Control. |
| STALL | DCO Output Updates Stall. 0 (DISABLED): In phase-lock and frequency-lock modes, spectrum spreading, and dithering operate normally, if enabled. 1 (ENABLED): In phase-lock and frequency-lock modes, spectrum spreading, and dithering are prevented from updating the output of the DCO. |
| DITHEN | Dithering Enable. 0 (DISABLED): Automatic DCO output dithering disabled. 1 (ENABLED): Automatic DCO output dithering enabled. |
| EDGSEL | Edge Lock Select. 0 (FALLING_EDGE): Lock DCO output frequency to the falling edge of the reference frequency. 1 (RISING_EDGE): Lock DCO output frequency to the rising edge of the reference frequency. |
| OUTMD | PLL Output Mode. 0 (OFF): DCO output is off. 1 (DCO): DCO output is in Free-Running DCO mode. 2 (FLL): DCO output is in frequency-lock mode (reference source required). 3 (PLL): DCO output is in phase-lock mode (reference source required). |